Fujitsu SPARC Enterprise T5120 안전 및 규정 준수 매뉴얼 - 페이지 13
{카테고리_이름} Fujitsu SPARC Enterprise T5120에 대한 안전 및 규정 준수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu SPARC Enterprise T5120 34 페이지. Sparc enterprise
Fujitsu SPARC Enterprise T5120에 대해서도 마찬가지입니다: 개요 매뉴얼 (34 페이지), 시작하기 매뉴얼 (12 페이지), 사이트 계획 매뉴얼 (26 페이지), 시작하기 매뉴얼 (12 페이지)
페이지 인쇄
Safety Agency Compliance
Statements
English
Safety Agency Compliance Statements
Read this section before beginning any procedure. The
following text provides safety precautions to follow when
installing a Fujitsu product.
Safety Precautions
For your protection, observe the following safety
precautions when setting up your equipment:
Follow all cautions and instructions marked on the
■
equipment.
Ensure that the voltage and frequency of your power
■
source match the voltage and frequency inscribed on
the equipment's electrical rating label.
Never push objects of any kind through openings in
■
the equipment. Dangerous voltages may be present.
Conductive foreign objects could produce a short
circuit that could cause fire, electric shock, or damage
to your equipment.
Symbols
The following symbols may appear in this book:
Caution – There is a risk of personal injury
and equipment damage. Follow the
instructions.
Caution – Hot surface. Avoid contact.
Surfaces are hot and may cause personal
injury if touched.
Caution – Hazardous voltages are present. To
reduce the risk of electric shock and danger to
personal health, follow the instructions.
Depending on the type of power switch your device has,
one of the following symbols may be used:
On – Applies AC power to the system.
Off – Removes AC power from the system.
Standby – The On/Standby switch is in the
standby position.
Modifications to Equipment
Do not make mechanical or electrical modifications to the
equipment. Fujitsu is not responsible for regulatory
compliance of a modified Fujitsu product.
Placement of a Fujitsu Product
Caution – Do not block or cover the openings
of your Fujitsu product. Never place a Fujitsu
product near a radiator or heat register.
Failure to follow these guidelines can cause
overheating and affect the reliability of your
Fujitsu product.
Noise Level
Product: SPARC Enterprise T5120/T5220
■
Declared Noise emissions in accordance with ISO 9296.
For SPARC Enterprise T5120:
LWAd (1B=10dB)
LpAm
For SPARC Enterprise T5220:
LWAd (1B=10dB)
LpAm
Operating
Idling
7.0 B
7.0 B
59 dBA
59 dBA
Operating
Idling
7.4 B
7.4 B
63 dBA
63 dBA
xi