Fujitsu fi-6770 Series 사용자 설명서 - 페이지 15
{카테고리_이름} Fujitsu fi-6770 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu fi-6770 Series 26 페이지. Image scanner
Fujitsu fi-6770 Series에 대해서도 마찬가지입니다: 설치 절차 매뉴얼 (6 페이지), 브로셔 (2 페이지), 시작하기 매뉴얼 (14 페이지), 시작하기 매뉴얼 (26 페이지), 소모품 교체 및 청소 지침 (22 페이지)
1
Make sure that the computer is turned OFF.
2
Open the Cable Cover (ADF type only).
3
Connect the scanner to your computer either with a USB or SCSI cable.
• You cannot make both USB and SCSI cable connections at the same time.
• You cannot connect multiple computers to the scanner at the same time.
• If Kofax VRS is not used on the fi-6670A or fi-6770A, connect the cable to USB Connector 1 or SCSI
Connector 1 on the scanner.
• Turn off the scanner and your computer first when you switch the interface cable.
The following describes the requirements for connecting with the respective cables.
■
USB cable
• Be sure to use the USB cable which comes as an accessory with this scanner.
• When connecting to an USB hub, use the first stage USB hub that is closest to the computer. If you use the
second or later hub stages, the scanner may not operate correctly.
• If you connect the scanner with USB 2.0, it is required that the USB port and the Hub be compliant with USB
2.0. The scanning speed slows down when you connect the scanner with USB 1.1.
■
SCSI cable
Be careful not to damage any pins of the SCSI connector when connecting the scanner to your
computer.
• When using the scanner with a SCSI interface, the following types of SCSI cable and SCSI card must be
purchased.
• SCSI cable:
Use a SCSI cable whose connector on the computer side mates to the connector on the SCSI card installed on
your computer.
On the scanner side, use either of the following SCSI cable types depending on the connector (1 or 2) used:
SCSI Connector 1: 50-pin high-density type
SCSI Connector 2: 68-pin high-density type
• SCSI card:
Find the recommended SCSI card information on the Fujitsu website (FAQ):
http://www.fujitsu.com/global/support/computing/peripheral/scanners/scsi/
• In a SCSI daisy chain formation, connect the scanner so that it is the terminated device.
• The SCSI ID initially set at the factory is [5]. If the SCSI ID of another SCSI device is set to the same ID, change
the scanner's SCSI ID to [0] through [7].
4
Connect the Power cable to the Power Connector of your scanner and to the
power outlet.
ARNI N G
5
Close the Cable Cover (ADF type only).
Let the cables out from the side slots of the scanner.
Be sure to use the supplied power cable. Use of other power cables may cause electri-
cal shock or malfunction.
Do not use the supplied power cable for other products. Doing so may cause electrical
shock or malfunction.
3 Connecting the Cables
15