Fujitsu fi-6770 Series 사용자 설명서 - 페이지 22

{카테고리_이름} Fujitsu fi-6770 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu fi-6770 Series 26 페이지. Image scanner
Fujitsu fi-6770 Series에 대해서도 마찬가지입니다: 설치 절차 매뉴얼 (6 페이지), 브로셔 (2 페이지), 시작하기 매뉴얼 (14 페이지), 시작하기 매뉴얼 (26 페이지), 소모품 교체 및 청소 지침 (22 페이지)

Fujitsu fi-6770 Series 사용자 설명서
5

Test-Scanning Documents

Using ScandAll PRO, you can test-scan documents to check if they are scanned with the ADF correctly.
For how to scan documents with the flatbed, refer to "Chapter 5 Various Documents" in the Operator's
Guide.
The following describes how to test-scan a document:
1
Turn on the scanner.
1) Press the "I" side of the main power switch of the scanner.
2) Press the [Power] button on the Operator Panel.
The scanner is turned ON, and the Power LED on the Operator Panel lights in green.
Note that while the scanner is being initialized, the indication of the Function Number Display
changes as; "8"
2
Turn on your computer.
3
The scanner is automatically detected, and
the [Found New Hardware] dialog box
appears.
Select [Locate and install driver software
(recommended)] to install the driver,
following the on-screen instructions.
22
"P"
"1", where "1" means that the Operator Panel is in the Ready Status.
If you see an error indication other than the above on the Function Number Display, refer to "Chapter
8 Troubleshooting" in the Operator's Guide.
Ex. :If "U" is displayed on the Function Number Display, it means that the Transport Lock remains
locked. In such case, you need to unlock the Transport Lock.
For how to unlock the Transport Lock, refer to "Section 2 Installing the Scanner" (on page 12).
ADF type
Operator Panel
Function
Scan / Stop
Check
Send to
Function Number Display
For a SCSI connection, turn on the scanner and confirm that the Function Number Display shows "1."
Then, turn on your computer.
If the connection is made via SCSI Connector 2, there is no need to install the driver here.
Just select [Don't show this message again for this device].
Flatbed type
Power
[Power] button
Operator Panel
Check
Function Number
Display
Function
Send to
Scan / Stop
Power
[Power] button