Fujitsu fi-6800 시작하기 매뉴얼 - 페이지 6

{카테고리_이름} Fujitsu fi-6800에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu fi-6800 9 페이지. Image scanner
Fujitsu fi-6800에 대해서도 마찬가지입니다: 사양 (2 페이지), 시작하기 매뉴얼 (8 페이지), 시작하기 매뉴얼 (8 페이지), 사양 (4 페이지), 소모품 교체 및 청소 지침 (26 페이지), 편리한 조작 (24 페이지), 시작하기 (6 페이지)

페이지 인쇄

-The SCSI ID initially set at the factory is [5].

If the SCSI ID of another SCSI device is set

to the same ID, change the scanner's SCSI

ID to [0] through [6].

Connect the power cable to the power

connector of your scanner and to the

power outlet.

WARNING

Be sure to use the supplied power cable.

The following cases may cause electrical

shock or malfunction.

Using a power cable other than that

supplied

Using the supplied power cable for other

devices

Test-Scanning Documents

Using ScandAll PRO, you can test-scan docu-

ments to check if they are scanned correctly.

The following describes how to test-scan a

document:

Turn on the scanner.

1. Press the "I" side of the main power switch on

the rear side of the scanner.

2. Press the power button on the front of the

scanner. The scanner is turned ON, the

power button lights in blue, and the liquid

crystal display (LCD) shows [Ready].

If you see an error indication other

than the above on the LCD, refer to

"Chapter 8 Troubleshooting" in the

Operator's Guide.

Replace the current operator panel overlay

with the one for the language to be used,

and specify the language to be shown on

the LCD.

For how to replace the overlay and specify

the language setting, refer to "Chapter 4 How

to Use the Operator Panel" in the Operator's

Guide.

Turn on your computer.

For a SCSI connection, turn on the

scanner and confirm that the LCD

shows [Ready]. Then, turn on your

computer.

The scanner is automatically detected,

and the [Found New Hardware] dialog box

appears. Select [Locate and install driver

software (recommended)] to install the

driver, following the on-screen instructions.

If the connection is made via SCSI

Connector 2, there is no need to

install the driver here. Just click

[Don't show this message again for

this device].

Load a sheet into the scanner.

For loading a sheet, refer to "2.1 Loading

Documents" in the Operator's Guide.

Launch ScandAll PRO.

Select the [Start] menu

[Fujitsu ScandAll PRO]

Select the [Tool] menu

The [Setup] dialog box appears.

On the [Scan] tab, select a driver to use,

and then click the [OK] button.

When the connection is made via SCSI/USB

Connector 2, click [ISIS/VRS].

LCD

Function

/Enter

Send to

Clear

Check

/Pause

/Back

Overlay

Stop

Scan

Counter

iMFF

Reset

Eject

Power Button

[All Programs]

[ScandAll PRO].

[Preferences].