Fujitsu M4099D-VRS 설치 절차 - 페이지 2
{카테고리_이름} Fujitsu M4099D-VRS에 대한 설치 절차을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu M4099D-VRS 3 페이지. Scsi (650) vrs scanner installation on windows me\2000\xp
Fujitsu M4099D-VRS에 대해서도 마찬가지입니다: 설치 절차 (3 페이지)
페이지 인쇄
Fujitsu SCSI
Scanner Installation Procedures with
The M4097D has the "L" bracket shipping lock.
1. Slide the scanner to its side as shown in figure below.
2. Unscrew the retainer screw and remove the shipping bracket.
3. Place the shipping bracket in the "use position" slot and secure it with the
retainer screw (see figure below)
4. Place scanner back in its normal position
Step D: Connecting the Scanner.
Warning! Before proceeding ensure that the power is off when connecting or
disconnecting the SCSI cable to the scanner or workstation. Failure to follow the
procedure above could result in damage to the SCSI card, scanner, and/or your system.
Termination and the SCSI ID's for both the M4097D and M4099D VRS
scanners are handled automatically. Connect the SCSI cable to the Kofax
controller and to the Wide SCSI (68-pin) port on the scanner. Ensure all
connections are securely fastened.
Connect the power cord to the scanner and a wall outlet. Boot up the host PC
first and then turn on the scanner. Listen to and watch the back of the
Rev010807L
Windows 2000 / XP
VRS (GSA-1)
Page 2 of 3