Fujitsu M4099D-VRS 설치 절차 - 페이지 3
{카테고리_이름} Fujitsu M4099D-VRS에 대한 설치 절차을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu M4099D-VRS 3 페이지. Scsi (650) vrs scanner installation on windows me\2000\xp
Fujitsu M4099D-VRS에 대해서도 마찬가지입니다: 설치 절차 (3 페이지)
페이지 인쇄
Fujitsu SCSI
Scanner Installation Procedures with
scanner. There are two LED's on the grayscale adaptor (GSA) card installed in
the scanner. During scanner power up both LED's will be on. After the first
scanner reset the green LED will turn off. Then after the second scanner reset
the yellow LED will turn off indicating that the scanner is ready and
communicating to the host PC.
Step E: Scanning with VCDEMO
1. Go to Start, Programs, Kofax VRS or Kofax Image Controls, and select
VCDEMO.EXE.
2. Next go to Source, Scanner, and click on the drop down arrow; then
select either the Fuji 4097or Fuji 4099 Virtual Rescan Source. Wait a few
seconds for the Kofax engine to load, and then place your documents in the
scanner.
3. Now go to Source, Properties and select your scanning parameters (i.e.
scan source - Flatbed or ADF, resolution, paper size).
4. Next right click on the VRS symbol in your system tray (lower right corner of
the screen) to access the VRS configuration settings.
5. Afterwards go to Source, and click on Process Image for single page scans
or Process Batch for multi-page batch scans.
Congratulations! You have successfully completed and tested your VRS scanner
installation.
Step F: Installing third party software applications.
After you have successfully installed all the Fujitsu software and hardware, then it is
time to install any additional third party scanning software that you wish to use. Please
follow the software manufacturer's instructions for installation. Remember when
installing any software that contains Kofax's Image Controls pay close attention to the
individual runtimes. It is strongly recommended that you install the oldest/lower
runtime application first.
Rev010807L
Windows 2000 / XP
VRS (GSA-1)
Page 3 of 3