A-M Systems 2100 사용 설명서 - 페이지 10

{카테고리_이름} A-M Systems 2100에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. A-M Systems 2100 19 페이지. Isolated pulse stimulator

Demonstration of Burst Mode

Connect the output of the Model 2100 to an oscilloscope. Before connecting the Model

2100 to any other instrument, or the experimental preparation, it is safest to turn its

power off.

Set the Output controls:

Range:

Pulse Sign:

Baseline:

Pulse Amplitude:

Baseline Amplitude

Setting The Timing Controls:

Delay:

Burst Width:

Duration:

Period:

Set the START controls as follows:

Mode:

Disconnect any cables to the TRIG or GATE inputs.

Trigger the oscilloscope from the Burst trigger out (upper Trig Out connector) for a

stable display. In each burst (occurring every l00ms), you should observe a trio of

15ms duration starting 50ms apart. Try switching the Start/Mode from Free Run to the

center (normal) position. The pulses will no longer be produced, and the Trig and

Event indicators will turn off. Pressing this switch once (to Manual) will cause a single

burst to occur.

A-M Systems

131 Business Park Loop, P.O. Box 850 Carlsborg, WA 98324

Telephone: 800-426-1306 * 360-683-8300 * FAX: 360-683-3525

E-mail: [email protected] * Website:

10V

2.00

1.00

8.80 * 10

-2

1.20 * 10

-2

1.50 * 10

5.00 * 10

-2

Free Run

http://www.a-msystems.com