A-M Systems 2100 사용 설명서 - 페이지 5

{카테고리_이름} A-M Systems 2100에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. A-M Systems 2100 19 페이지. Isolated pulse stimulator

페이지 인쇄

Controls and Connectors

The controls for the Model 2100 are grouped in three sections:

when a pulse or burst of pulses begins;

or more pulses; and

Start

Determines the polarity of valid trigger pulses

TRIG SLOPE:

(positive or negative edges in the trigger signal).

Controls waveform initiation. When set to

MODE:

one timing cycle immediately follows the last. When

momentarily placed in the

starts immediately. When the switch is in the center

position, timing cycles start when valid triggering events

occur.

This LED lights up when a timing cycle is in process

TRIG'D:

and continues until the burst is completed.

This BNC connector allows a signal from an external

TRIG:

source to initiate timing cycles. It is set for standard TTL

levels.

This BNC connector allows a signal from an external source to restrict the final

GATE:

output signal. This input must be at a logical high (or open-circuited) in order for the

Model 2100 to recognize either manual or automatic trigger events.

Valid triggers (represented by the arrows in the figure) can occur only when the gate

is at logical high. Note that the up arrow would apply only if

the down arrows would apply only if

Note: Triggers have no effect if the system has not completed its response to a

previous trigger.

A-M Systems

TIMING

, which controls the amplitude of the output signal.

OUTPUT

position, a timing cycle

MANUAL

TRIG SLOPE

131 Business Park Loop, P.O. Box 850 Carlsborg, WA 98324

Telephone: 800-426-1306 * 360-683-8300 * FAX: 360-683-3525

E-mail: [email protected] * Website:

START

, which controls the on/off timing of one

FREE RUN,

TRIG SLOPE

is set to -.

http://www.a-msystems.com

, which controls

is set to +;