Fujitsu 200 사용자 설명서 - 페이지 5

{카테고리_이름} Fujitsu 200에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu 200 8 페이지. Harsh environment case for pencentra 130
Fujitsu 200에 대해서도 마찬가지입니다: 사용자 설명서 (2 페이지), 사양 시트 (2 페이지), 사용자 설명서 (2 페이지), 사용자 지침 (1 페이지), 사용자 지침 (1 페이지), 사용자 지침 (2 페이지)

페이지 인쇄

58-0581-01.fm Page 5 Tuesday, August 21, 2001 9:28 AM

Operational Considerations

Issues to consider when you use the FMW51BC1 or

FMW51BC2 battery charger are discussed as follows:

You can insert up to two battery packs at a time in the

battery charger. When charging two battery packs, you can

insert or remove either battery pack independently.

The battery charger only charges one battery pack at a

time. When two battery packs are inserted in the charger,

the battery pack installed first is charged first.

The battery charger will indicate a full charge level and

will not begin charging the battery pack if the battery pack

charge level is 90% or higher when the battery pack is

initially inserted in the charger. This prevents the battery

pack from being overcharged.

When you remove the battery pack from your pen tablet,

always insert a charged battery pack in the pen tablet to

replace the one that you removed, or apply DC power.

The FMW51BP1, FMW29BP1, FMW29BP2, FMW43BP2

and FPCBP48 battery packs use lithium ion battery cells

which have no "memory effect." You do not need to com-

pletely discharge or "condition" the battery pack before

charging.

Battery Pack Charge Time

The approximate maximum amount of time needed to

charge a fully discharged battery pack to the 90% level is

shown in the following table. Note that when two battery

packs are installed in the charger, they are charged sequen-

tially (starting with the battery pack that is installed first).