Fujitsu eternus af 구성 매뉴얼 - 페이지 19

{카테고리_이름} Fujitsu eternus af에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu eternus af 32 페이지. Fibre channel for citrix xenserver
Fujitsu eternus af에 대해서도 마찬가지입니다: 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (25 페이지), 구성 매뉴얼 (43 페이지)

페이지 인쇄

Chapter 8

Setting Up XenServer

Set up XenServer to connect the ETERNUS DX/AF.

The settings described in this chapter are performed using Citrix XenCenter applications. Prepare a XenCenter

environment before setting up XenServer. For details on how to install and operate XenCenter, refer to the

Citrix documents.

The screenshots in this manual were captured using XenCenter version 5.5.0.

8.1

Setting Up the Fibre Channel Cards

Perform Fibre Channel card settings.

8.1.1

For PRIMERGY

The required procedures vary depending on the Fibre Channel card product ID. For Fujitsu Emulex Fibre Chan-

nel cards, refer to

8.1.2

For Fujitsu Emulex Fibre Channel Cards

This section explains how to install Emulex Fibre Channel cards in the XenServer host and how to connect the

ETERNUS DX/AF.

For the installation procedure and functions regarding XenCenter, refer to the manuals that can be obtained

on the following Citrix web-site:

https://www.citrix.com/support/

Since the standard driver that is supplied with the OS is used for the Fibre Channel driver, other drivers do

not need to be installed.

Use the following procedure to set the drive parameters.

Use the OneCommand Manager Command Line Interface or the HBAnyware Command Line Interface

•

that are installed in XenServer as standard to set the driver parameters. For mode details, refer to help.

Set the parameters without the ETERNUS DX/AF connected.

•

FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Citrix

"8.1.2 For Fujitsu Emulex Fibre Channel Cards" (page

"8.1.3 For Fujitsu QLogic Fibre Channel Cards" (page

19). For Fujitsu QLogic Fibre Chan-

21).

XenServer

P3AM-4572-19ENZ0