Fujitsu eternus af 구성 매뉴얼 - 페이지 18

{카테고리_이름} Fujitsu eternus af에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu eternus af 43 페이지. Fibre channel for citrix xenserver
Fujitsu eternus af에 대해서도 마찬가지입니다: 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (25 페이지), 구성 매뉴얼 (32 페이지)

페이지 인쇄

Chapter 7

Installing Drivers and Setting Up the Server

7.1

Installing the Driver

Install the necessary drivers and patches following the Fibre Channel card installation guide.

7.2

Setting Up the Server

The server control environment now needs to be set up.

Set the command queue depth and the maximum number of volume groups for the server environment.

7.2.1

Setting Up the Command Queue Depth

Set the number of commands allowed to be queued (command queue depth) on each LUN in the ETERNUS

AF/DX storage systems from the Fibre Channel card. This setting optimizes the connection between the ETER-

NUS AF/DX storage systems and the server.

Model

ETERNUS AF/DX

*1: Recommended value = (maximum number of simultaneous command processes per CA port) ¸ (num-

ber of Fibre Channel ports connected to a single CA port) ¸ (number of LUNs)

(Round the result down to the nearest whole number)

•

The maximum number of simultaneous command processes per CA port is as follows:

The value is used by multiple servers that share the CA port. The commands are processed until the

limit is reached.

Model

ETERNUS AF S3 series, ETERNUS DX S5 series, ETERNUS

DX8900 S4

Models other than the above

Use the value of "8" if the actual result is lower. Use the maximum value if the actual result exceeds

•

the maximum value of the OS or the driver.

To achieve maximum system performance, this value can be changed according to the server load

•

and the peak operating times.

FUJITSU Storage ETERNUS AF, ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for HP-UX

Setting value

Command queue depth

Arbitrary (*1)

Maximum number of simultaneous command processes

2048

1024

P3AM-3772-22ENZ0