Fujitsu eternus af Посібник з конфігурації - Сторінка 18

Переглянути онлайн або завантажити pdf Посібник з конфігурації для Зберігання Fujitsu eternus af. Fujitsu eternus af 43 сторінки. Fibre channel for citrix xenserver
Також для Fujitsu eternus af: Посібник з конфігурації (28 сторінок), Посібник з конфігурації (25 сторінок), Посібник з конфігурації (32 сторінок)

Chapter 7

Installing Drivers and Setting Up the Server

7.1

Install the necessary drivers and patches following the Fibre Channel card installation guide.

7.2

The server control environment now needs to be set up.

Set the command queue depth and the maximum number of volume groups for the server environment.

7.2.1

Set the number of commands allowed to be queued (command queue depth) on each LUN in the ETERNUS

AF/DX storage systems from the Fibre Channel card. This setting optimizes the connection between the ETER-

NUS AF/DX storage systems and the server.

Model

ETERNUS AF/DX

*1: Recommended value = (maximum number of simultaneous command processes per CA port) ¸ (num-

ber of Fibre Channel ports connected to a single CA port) ¸ (number of LUNs)

(Round the result down to the nearest whole number)

•

The maximum number of simultaneous command processes per CA port is as follows:

The value is used by multiple servers that share the CA port. The commands are processed until the

limit is reached.

Model

ETERNUS AF S3 series, ETERNUS DX S5 series, ETERNUS

DX8900 S4

Models other than the above

Use the value of "8" if the actual result is lower. Use the maximum value if the actual result exceeds

•

the maximum value of the OS or the driver.

To achieve maximum system performance, this value can be changed according to the server load

•

and the peak operating times.

FUJITSU Storage ETERNUS AF, ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for HP-UX

Setting value

Command queue depth

Arbitrary (*1)

Maximum number of simultaneous command processes

2048

1024

P3AM-3772-22ENZ0