Fujitsu ETERNUS DX Disk 구성 매뉴얼 - 페이지 9

{카테고리_이름} Fujitsu ETERNUS DX Disk에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX Disk 29 페이지. Server connection, fcoe for linux driver settings for converged network adapter cards
Fujitsu ETERNUS DX Disk에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 사용자 설명서 (42 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (44 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (25 페이지), 구성 매뉴얼 (32 페이지), 구성 매뉴얼 (35 페이지), 구성 매뉴얼 (31 페이지), 구성 매뉴얼 (43 페이지), 구성 매뉴얼 (21 페이지), 구성 매뉴얼 (24 페이지)

페이지 인쇄
Fujitsu ETERNUS DX Disk 구성 매뉴얼
Chapter 4
Setting Up the Server
The server setup will vary according to how the ETERNUS DX/AF storage systems and server are to be connec-
ted. Edit the server's configuration file to match the chosen topology. Configuration files may also differ de-
pending on which Fibre Channel cards are to be used.
There are two possible connection topologies: direct connection and switch connection. Procedures are de-
scribed below. Also refer to the FUJITSU PCI Fibre Channel manuals as necessary.
●
For direct connection
Instance name data of the Fibre Channel card is necessary. Refer to the following sections to set.
•
"4.1 Creating a WWN Instance Management Table for the Server" (page 9)
"4.2 Creating a WWN Instance Management Table for Storage System" (page 12)
•
"4.4 Setting the Configuration File (fjpfca.conf)" (page 14)
•
"4.5 Re-checking the Settings" (page 14)
•
●
For switch connection
The Fibre Channel card Instance name, target WWN, and target ID information are necessary. Check each
item and enter them in the table. Edit the configuration file according to those information and make set-
tings.
Refer to the following sections to set.
"4.1 Creating a WWN Instance Management Table for the Server" (page 9)
•
"4.2 Creating a WWN Instance Management Table for Storage System" (page 12)
•
"4.3 Creating a Target Binding Table" (page 13)
•
•
"4.4 Setting the Configuration File (fjpfca.conf)" (page 14)
"4.5 Re-checking the Settings" (page 14)
•
4.1
Creating a WWN Instance Management Table for the Server
Create a "WWN instance management table for the server" with information regarding the Fibre Channel
card.
Determine the following information for each Fibre Channel card installed in the server and enter it into a
copy of the "WWN instance management table for the server" (provided in
Table Templates" (page
Physical slot name
•
WWN
•
Instance name
•
Physical path name
•
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
25)).
9
Copyright 2017 FUJITSU LIMITED
"Appendix A Various Management
P3AM-3712-15ENZ0