Fujitsu ETERNUS DX Disk Yapılandırma Kılavuzu - Sayfa 9

Depolama Fujitsu ETERNUS DX Disk için çevrimiçi göz atın veya pdf Yapılandırma Kılavuzu indirin. Fujitsu ETERNUS DX Disk 29 sayfaları. Server connection, fcoe for linux driver settings for converged network adapter cards
Ayrıca Fujitsu ETERNUS DX Disk için: Kullanıcı Kılavuzu (35 sayfalar), Kullanıcı Kılavuzu (42 sayfalar), Yapılandırma Kılavuzu (28 sayfalar), Yapılandırma Kılavuzu (44 sayfalar), Yapılandırma Kılavuzu (28 sayfalar), Yapılandırma Kılavuzu (25 sayfalar), Yapılandırma Kılavuzu (32 sayfalar), Yapılandırma Kılavuzu (35 sayfalar), Yapılandırma Kılavuzu (31 sayfalar), Yapılandırma Kılavuzu (43 sayfalar), Yapılandırma Kılavuzu (21 sayfalar), Yapılandırma Kılavuzu (24 sayfalar)

Sayfayı Yazdır
Fujitsu ETERNUS DX Disk Yapılandırma Kılavuzu
Chapter 4
Setting Up the Server
The server setup will vary according to how the ETERNUS DX/AF storage systems and server are to be connec-
ted. Edit the server's configuration file to match the chosen topology. Configuration files may also differ de-
pending on which Fibre Channel cards are to be used.
There are two possible connection topologies: direct connection and switch connection. Procedures are de-
scribed below. Also refer to the FUJITSU PCI Fibre Channel manuals as necessary.
●
For direct connection
Instance name data of the Fibre Channel card is necessary. Refer to the following sections to set.
•
"4.1 Creating a WWN Instance Management Table for the Server" (page 9)
"4.2 Creating a WWN Instance Management Table for Storage System" (page 12)
•
"4.4 Setting the Configuration File (fjpfca.conf)" (page 14)
•
"4.5 Re-checking the Settings" (page 14)
•
●
For switch connection
The Fibre Channel card Instance name, target WWN, and target ID information are necessary. Check each
item and enter them in the table. Edit the configuration file according to those information and make set-
tings.
Refer to the following sections to set.
"4.1 Creating a WWN Instance Management Table for the Server" (page 9)
•
"4.2 Creating a WWN Instance Management Table for Storage System" (page 12)
•
"4.3 Creating a Target Binding Table" (page 13)
•
•
"4.4 Setting the Configuration File (fjpfca.conf)" (page 14)
"4.5 Re-checking the Settings" (page 14)
•
4.1
Creating a WWN Instance Management Table for the Server
Create a "WWN instance management table for the server" with information regarding the Fibre Channel
card.
Determine the following information for each Fibre Channel card installed in the server and enter it into a
copy of the "WWN instance management table for the server" (provided in
Table Templates" (page
Physical slot name
•
WWN
•
Instance name
•
Physical path name
•
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
25)).
9
Copyright 2017 FUJITSU LIMITED
"Appendix A Various Management
P3AM-3712-15ENZ0