Fujitsu ETERNUS DX100 S3 구성 매뉴얼 - 페이지 10
{카테고리_이름} Fujitsu ETERNUS DX100 S3에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX100 S3 13 페이지. Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu ETERNUS DX100 S3에 대해서도 마찬가지입니다: 수동 서버 연결 구성 (12 페이지), 수동 서버 연결 구성 (12 페이지), 구성 매뉴얼 (28 페이지), 설정 매뉴얼 (15 페이지), 안전 주의사항 (12 페이지)
![Fujitsu ETERNUS DX100 S3 구성 매뉴얼](/uploads/products/server2/2443546/2443546.jpg)
Chapter 2
Setting Up the ETERNUS DX
2.1
Common Settings
2.1.3
Setting the Host Responses
The host response parameters for the ETERNUS DX must be set to match the way the server processes the
responses to requests from the ETERNUS DX. Setting of the host response must be done before connecting
the ETERNUS DX to the server.
Set the parameters that are described below for each OS.
Retain the default values for all of the parameters that are not described below.
When setting the access path using the ETERNUS SF Storage Cruiser, the host responses for FC host will be
set to default values. Set the host response after setting the access path using the ETERNUS SF Storage
Cruiser.
Table 2.5 Host response settings
OS
Solaris (*1)
®
Windows
Linux
VMware ESX
Citrix XenServer
Oracle VM Server for x86
HP-UX
AIX
IBM SVC
*1: An Oracle-brand Fibre Channel card driver may be used for Fujitsu Fibre Channel cards.
To confirm which driver should be used, check the "Notes" and "Fibre Channel Cards that Require an Ora-
cle-brand Driver" sections in "FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fi-
bre Channel) for Oracle Solaris".
2.1.4
Setting the CA Port Groups
Create new FC port groups and register the ports as members of the groups. A port group is a group of ports
that access the same LUN group (ports that are used for multipath connection to the server or for connecting
to the cluster configuring server). Configure the host affinity setting for each FC port group.
2.1.5
Registering the WWNs of the Accessing Fibre Channel Cards (Setting FC Host)
Register the WWN of each Fibre Channel card installed in the server that will access the ETERNUS DX. At the
same time, set the host response numbers registered in
cept these WWNs.
Registering the FC host WWNs and setting up Host Affinities as described elsewhere, allows limits to be set
on which servers are allowed to access which ETERNUS DX LUNs.
Conditions
When using the OS standard Multipath Driver
(MPxIO)
Other cases
–
–
When using Symantec Storage Foundation
Other cases
–
10
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Copyright 2015 FUJITSU LIMITED
Host response selection
Solaris MPxIO
Default
Default
HP-UX
AIX VxVM
AIX
SVC
"2.1.3 Setting the Host Responses" (page 10)
to ac-
P3AM-7962-08ENZ0