Fujitsu ETERNUS DX100 S3 설정 매뉴얼
{카테고리_이름} Fujitsu ETERNUS DX100 S3에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX100 S3 15 페이지. Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu ETERNUS DX100 S3에 대해서도 마찬가지입니다: 수동 서버 연결 구성 (12 페이지), 수동 서버 연결 구성 (12 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (13 페이지), 안전 주의사항 (12 페이지)
페이지 인쇄
FUJITSU Storage
ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems
Preparation
STEP
An installation space and network environment must be prepared in advance.
Prepare the following manuals:
●
Manuals for the ETERNUS DX100 S3/DX200 S3
●
Related manuals, such as manuals for the server or the networking equipment that is used
Installation Space
Site Planning Guide
Installation space
Check that the installation area meets the space requirements of the rack in which the ETERNUS DX is to be
installed.
Environmental considerations for installation
Check if the installation area for the ETERNUS DX meets the environmental conditions and installation environment
conditions.
Power outlets
Check the type and the number of power outlets/sockets that are required to install the ETERNUS DX.
Network Environment
Configuration Guide (Basic)
•
Configuration Guide (Web GUI)
•
Completing and attaching the Network Settings label
Write down the IP address for the ETERNUS DX on the Network Settings label and attach it inside the rack.
Settings for the PC
●
Set up the network environment
-
IP address : 192.168.1.2
-
Subnet mask : 255.255.255.0
●
Set the Web browser
Refer to "Configuration Guide (Web GUI)" for details on the settings that are required.
Setup Guide
Setup Guide
P3AM-7852-06ENZ0