Fujitsu ETERNUS DX100 S3 설정 매뉴얼 - 페이지 13
{카테고리_이름} Fujitsu ETERNUS DX100 S3에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX100 S3 15 페이지. Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu ETERNUS DX100 S3에 대해서도 마찬가지입니다: 수동 서버 연결 구성 (12 페이지), 수동 서버 연결 구성 (12 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (13 페이지), 안전 주의사항 (12 페이지)
![Fujitsu ETERNUS DX100 S3 설정 매뉴얼](/uploads/products/server2/2443546/2443546.jpg)
5.
Host affinity creation
Create an association between a host group and a port
group and an association between a host group and a
LUN group.
To display the screen to create a host affinity:
Click the [Connectivity] tab, and then click [Create Host
Affinity] in [Action].
Monitoring Setup
STEP
Perform the ETERNUS DX monitoring setup if required.
●
Notification of the ETERNUS DX problems as they occur is possible if the event notification method and level
have been set.
If remote support is required, the ETERNUS DX needs to be set to notify the remote support center of failures.
●
Remote support allows prompt detection and resolution of trouble.
Point
Configuration Guide (Basic)
Server Connection
STEP
Perform the settings required to connect to the server and install the required drivers. Perform the settings required
for network devices connecting the server and the ETERNUS DX.
After the server connection setup, confirm that the volumes in the ETERNUS DX can be recognized by the server.
All necessary settings are complete, and the ETERNUS DX is now ready for normal operation.
Configuration Guide (Basic)
•
Configuration Guide -Server Connection-
•
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Setup Guide
13
Copyright 2017 FUJITSU LIMITED
P3AM-7852-06ENZ0