Fujitsu ETERNUS DX100 S3 설정 매뉴얼 - 페이지 11
{카테고리_이름} Fujitsu ETERNUS DX100 S3에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX100 S3 15 페이지. Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu ETERNUS DX100 S3에 대해서도 마찬가지입니다: 수동 서버 연결 구성 (12 페이지), 수동 서버 연결 구성 (12 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (13 페이지), 안전 주의사항 (12 페이지)
페이지 인쇄
RAID Configuration Settings
7
Use ETERNUS Web GUI to set RAID configurations in the ETERNUS DX.
Perform the following settings:
●
RAID group creation
●
Volume creation
●
Hot spare registration
1.
RAID group creation
Create RAID groups to create volumes.
To display the screen to create RAID groups:
Click the [RAID Group] tab, and then click [Create]
in [Action].
2.
Volume creation
Create volumes in the RAID group.
To display the screen to create volumes:
Click the [Volume] tab, and then click [Create] in
[Action].
3.
Hot spare registration
Register the hot spare for the failure of a drive.
To display the screen to register the hot spare:
Click the [Component] tab, and then click [Drives] in [Category].
Global Hot Spare registration
●
Select the drive that is to be registered as the
Global Hot Spare and click [Assign Global HS] in
[Action]. In the confirmation screen that appears,
click the [OK] button.
●
Dedicated Hot Spare registration
Select the drive that is to be registered as the
Dedicated Hot Spare and click
[Assign Dedicated HS] in [Action].
Select which RAID group to use the selected drive
as a Dedicated Hot Spare for and click the [Assign]
button. In the confirmation screen that appears,
click the [OK] button.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Setup Guide
11
Copyright 2017 FUJITSU LIMITED
P3AM-7852-06ENZ0