Fujitsu ETERNUS DX100 S3 설정 매뉴얼 - 페이지 6
{카테고리_이름} Fujitsu ETERNUS DX100 S3에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX100 S3 15 페이지. Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu ETERNUS DX100 S3에 대해서도 마찬가지입니다: 수동 서버 연결 구성 (12 페이지), 수동 서버 연결 구성 (12 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (13 페이지), 안전 주의사항 (12 페이지)
페이지 인쇄
LAN Cable
1
●
MNT port
A port that is used to connect to an operation management LAN. Before connecting to the operation
management LAN, change the IP address of the MNT port in the Setup Network Environment settings.
●
RMT port
A port that is used for initial setup or to connect to the remote support center.
Cable
Host Interface Cable
2
Connect a Host Interface cable to each of these ports.
Cable
●
FC,
iSCSI 10Gbit/s (10GBASE-SR),
FCoE,
Ethernet 10Gbit/s
(for FC cable connection)
●
iSCSI 10Gbit/s (10GBASE-SR),
FCoE,
Ethernet 10Gbit/s
(for Copper Twinax cable
connection)
●
iSCSI 10Gbit/s (10GBASE-T),
iSCSI 1Gbit/s,
Ethernet 1Gbit/s
SAS
●
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Setup Guide
Rear view
Controller (CM#0)
RMT port
MNT port
Rear view
CA#1
CA#0
CA#0
CA#1
FC
iSCSI 10Gbit/s (10GBASE-SR)
,
,
FCoE
Ethernet 10Gbit/s
,
for FC cable connection
(
)
Port#0
Port#1
iSCSI 10Gbit/s (10GBASE-T),
iSCSI 1Gbit/s
Port#0 Port#1
Ethernet 1Gbit/s
Port#0 Port#1 Port#2 Port#3
6
Copyright 2017 FUJITSU LIMITED
Controller (CM#1)
RMT port
MNT port
CA#1
CA#0
CA#0
CA#1
iSCSI 10Gbit/s (10GBASE-SR),
FCoE
Ethernet 10Gbit/s
,
(for Copper Twinax cable connection)
Port#0
Port#1
SAS
Port#0
Port#1
Controller enclosure
Controller enclosure
Controller enclosure
P3AM-7852-06ENZ0