Fujitsu ETERNUS DX100 S3 설정 매뉴얼 - 페이지 7
{카테고리_이름} Fujitsu ETERNUS DX100 S3에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX100 S3 15 페이지. Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu ETERNUS DX100 S3에 대해서도 마찬가지입니다: 수동 서버 연결 구성 (12 페이지), 수동 서버 연결 구성 (12 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (13 페이지), 안전 주의사항 (12 페이지)
페이지 인쇄
Mini SAS HD Cable Between Enclosures
3
When drive enclosures are installed, use mini SAS HD cables between enclosures to connect between the DI ports of
each enclosure.
When connecting the mini SAS HD cable between enclosures,
IMPORTANT
check the direction of the connector (the tab must be pointed
downward) and firmly insert all the way in.
Cable
●
DI (OUT) side plug
The " ■ " symbol is
printed here.
●
DI (IN) side plug
The "●" symbol is
printed here.
Attach the destination labels
to the plugs of the mini SAS HD
cables between enclosures.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Setup Guide
Rear view
●
Controller enclosure
The controller enclosure only has DI (OUT) ports.
Connect the connectors on which the " " symbol is printed.
DI
OUT
(
) port
●
Drive enclosure
DI
IN
DI (OUT) port
(
) port
●
Example of mini SAS HD cable connections between enclosures
(when two drive enclosures are installed)
Between Controller 0 and I/O module line 0, connect the drive enclosures
in ascending order of the drive enclosure numbers.
Between Controller 1 and I/O module line 1, connect the drive enclosures
in descending order of the drive enclosure numbers.
7
Copyright 2017 FUJITSU LIMITED
The DI (IN) port is on the left side and the DI (OUT) port is on
the right side of each I/O module.
Plug the connectors on which the " " symbol is printed into
the DI (IN) ports.
Plug the connectors on which the " " symbol is printed into
the DI (OUT) ports.
Tab
Drive enclosure 2
Drive enclosure 1
Controller enclosure
P3AM-7852-06ENZ0