Fujitsu ETERNUS DX200 S3 수동 서버 연결 구성 - 페이지 9

{카테고리_이름} Fujitsu ETERNUS DX200 S3에 대한 수동 서버 연결 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX200 S3 12 페이지. Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu ETERNUS DX200 S3에 대해서도 마찬가지입니다: 수동 서버 연결 구성 (12 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (13 페이지), 구성 매뉴얼 (18 페이지), 설정 매뉴얼 (15 페이지), 안전 주의사항 (12 페이지)

페이지 인쇄

1. Setting the To-Server Connection Type (Setting the Sas Port Parameters)

Chapter 2

Setting Up the ETERNUS DX

2.1

Common Settings

2.1.3

Setting the Host Responses

The host response parameters for the ETERNUS DX must be set to match the way the server processes the

responses to requests from the ETERNUS DX. Setting the host response must be done before connecting the

ETERNUS DX to the server.

Set the parameters that are described below for each OS.

Retain the default values for all of the parameters that are not described below.

Table 2.2 Host response settings

Solaris

Windows

VMware ESX

Linux

2.1.4

Setting the CA Port Groups

Create new SAS port groups and register the ports as members of the groups. A SAS port group is a group of

SAS-CA type ports that are connected to the specified host group. Configure the host affinity setting for each

SAS port group.

2.1.5

Registering the SAS Addresses of the Accessing SAS Cards (Setting SAS Host)

same time, set the host response registered in

SAS hosts (SAS addresses).

Registering the SAS hosts (SAS addresses) and setting up Host Affinities as described elsewhere, allows limits

to be set on which servers are allowed to access which ETERNUS DX storage systems.

When a server-side SAS card is replaced, the SAS address of the replacement SAS card must be re-regis-

tered to the ETERNUS DX.

Connect the SAS card that is installed in the server to the ETERNUS DX with the SAS cable.

Turn on the ETERNUS DX.

Turn on the server, and start the OS.

Acquire the SAS address of HBA from each port in the [Setup SAS Host] screen of ETERNUS Web GUI.

Conditions

When using the OS standard

Multipath Driver (MPxIO)

Other cases

–

For SUSE Linux Enterprise

Server 10

Other cases

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

Host response selec-

Parameter

tion

Solaris MPxIO

–

Default

–

Default

–

None

Sense Data Conversion

(Create a new host re-

sponse)

Default

–

"2.1.3 Setting the Host Responses" (page 9)

Setting value

–

b/c1/01 g 6/c1/01

–

to accept these

P3AM-8542-04ENZ0