Fujitsu ETERNUS DX200 S3 수동 서버 연결 구성 - 페이지 8

{카테고리_이름} Fujitsu ETERNUS DX200 S3에 대한 수동 서버 연결 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX200 S3 12 페이지. Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu ETERNUS DX200 S3에 대해서도 마찬가지입니다: 수동 서버 연결 구성 (12 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (13 페이지), 구성 매뉴얼 (18 페이지), 설정 매뉴얼 (15 페이지), 안전 주의사항 (12 페이지)

페이지 인쇄

1. Setting the To-Server Connection Type (Setting the Fcoe Port Parameters)

Chapter 2

Setting Up the ETERNUS DX

2.1

Common Settings

This section explains the settings required for all server OSes, regardless of the connection configuration.

See the "ETERNUS Web GUI User's Guide" for details of how to set up and operate ETERNUS Web GUI.

2.1.1

Setting the To-server Connection Type (Setting the FCoE Port Parameters)

For each connection configuration, set the indicated items only. All other parameters should be left on their

default values.

Table 2.1 FCoE port parameter settings

Parameter

Transfer Rate

Frame Size

Reset Scope

Release Reservation if Chip is Reset

Make sure to prepare and set up FCoE switches. For further details, refer to "Fabric OS Administrator's

Guide Supporting Fabric OS".

2.1.2

Creating the Server Accessible LUN Groups (Setting the LUN Groups)

Create LUN groups (Affinity Group) for the server to access. Refer to "Connectivity Management" in "ETERNUS

Web GUI User's Guide" for details, and set the LUN groups.

When the server OS is Windows

ascending order. The server cannot recognize the ETERNUS DX LUNs unless they are assigned in this order.

This restriction does not apply when the server is running a Solaris OS.

, Linux, or VMware ESX, assign LUN Group values starting from LUN0 in

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

Solaris OS, Windows

, Linux, VMware ESX

10 Gbit/s

2048 bytes (Default value)

I_T_L

Disable

P3AM-7982-05ENZ0