Fujitsu ETERNUS DX60 S2 사용자 설명서 - 페이지 32

{카테고리_이름} Fujitsu ETERNUS DX60 S2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX60 S2 42 페이지. Server connection. (fibre channel) for aix
Fujitsu ETERNUS DX60 S2에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 구성 매뉴얼 (28 페이지), 사용자 설명서 (14 페이지), 구성 매뉴얼 (16 페이지), 구성 매뉴얼 (38 페이지), 하드웨어 및 소프트웨어 설치 매뉴얼 (36 페이지)

Fujitsu ETERNUS DX60 S2 사용자 설명서
Chapter 6
Setting Up the VMware ESX Server
6.2
For VMware Infrastructure 3
6.2.3

Creating the Virtual Switches

Add two virtual switches (vSwitch) for iSCSI to VMware ESX.
Define two virtual network port types ("Service Console" and "VMkernel") for the added vSwitch.
Also assign IP addresses on the same subnet to the defined Service Console and VMkernel.
6.2.3.1
Adding a Service Console
1
Select the [Configuration] tab on VMware Infrastructure Client and click [Add Networking].
2
Select [Service Console] and click the [Next] button.
3
Select the checkbox of the target network adapter and click the [Next] button.
4
Check the [Service Console] details, set an arbitrary VLAN ID, IP address, and subnet mask, and click the
[Next] button.
5
Check the [Service Console] IP address and click the [Finish] button.
Confirm that the virtual switch (vSwitch1) has been created as follows.
6
Repeat
Step 1
6.2.3.2
Adding a VMkernel
1
Select the [Configuration] tab on VMware Infrastructure Client and select the target virtual switch' s
[Properties].
2
Click [Add].
3
Select the [VMkernel] radio button, and click the [Next] button.
4
Confirm that the VMkernel is displayed, set the IP address (an optional VLAN ID may be set, as necessa-
ry), and click the [Next] button.
5
Confirm the settings shown on the confirmation screen and click the [Finish] button.
A message about Gateway settings appears.
ETERNUS DX Disk storage systems User's Guide -Server Connection-(iSCSI) for VMware
through
Step 5
to add Service Console to vSwitch2.
32
Copyright 2013 FUJITSU LIMITED
®
ESX
P3AM-3412-13ENZ0