Fujitsu ETERNUS DX60 S3 사이트 계획 매뉴얼 - 페이지 39
{카테고리_이름} Fujitsu ETERNUS DX60 S3에 대한 사이트 계획 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX60 S3 41 페이지. Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu ETERNUS DX60 S3에 대해서도 마찬가지입니다: 수동 서버 연결 구성 (12 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (13 페이지), 안전 주의사항 (12 페이지)
페이지 인쇄
Chapter 2
Rack Installation Specifications
2.2
Installable Racks
Figure 2.6 Unit Installation Area
Front door of the rack
Table 2.3 Specifications for the Unit Installation Area
Specification
(1)
Rack front space
(Space between the fixed part of the ETERNUS DX on the
front side and the front of the rack)
(2)
Mount bracket length
(Size between each end of the front and rear rack pillars)
(3)
Rack space
(Space between the fixed part of the ETERNUS DX on the
front side and the rear of the rack)
(4)
Rack mount kit installation area
■
Placement Requirements
When determining service areas, refer to the manual of the rack that is to be used.
Make sure to perform the installation according to the placement requirements described in
Specifications" (page 10)
(1)
(2)
ETERNUS DX
(4)
Rack pillars
and
"1.6 Installation Environment" (page
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Site Planning Guide
Copyright 2015 FUJITSU LIMITED
(3)
Rack rails
Rear door of the rack
Condition
40mm or more
685mm or more
775mm or less
830mm or more
482mm or more
(recommended)
19).
39
"1.1 Installation
P3AM-8982-03ENZ0