Fujitsu ETERNUS DX8000 series 구성 매뉴얼 - 페이지 9

{카테고리_이름} Fujitsu ETERNUS DX8000 series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX8000 series 17 페이지.

페이지 인쇄

Chapter 2 ETERNUS DX Connection Settings

2.1 Common Settings

Reset Scope

Reserve Cancel at Chip Reset

Header Digest

Data Digest

2.1.2

Sense Data Conversion (Setting the Host Responses)

The ETERNUS DX host responses must be set to match the way in which the server will process the ETERNUS DX

request responses.

These are different for each OS and this must be done before connecting the ETERNUS DX to the server.

Retain the default values for all parameters not described below.

2.1.2.1

Solaris OS

For Solaris OS, perform the settings detailed in

Table 2.2

Reservation Conflict Response for Test Unit Ready setting for Solaris OS

Solaris 10 OS

Table 2.3

Sense Data Conversion Pattern setting for Solaris OS

Solaris 10 OS

2.1.2.2

HP-UX

For HP-UX, set the [Host Specific Mode] to [HP-UX Mode (SCC)].

Table 2.4

Host Specific Mode setting for HP-UX

HP-UX

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

Parameter

I_T_L (Default value)

OFF (Default value)

[Sense Data Conversion Pattern]

[Host Specific Mode] setting

Solaris OS, HP-UX, Windows®, Linux, VMware ESX, Oracle VM Server

Table 2.2

and

Table

2.3.

MPxIO (OS standard Multipath Driver)

Used

Conflict Response

setting

Linux Recommended

(When not using GRMPD)

HP-UX Mode (SCC)

Not used

Normal Response (Default)

P3AM-3972-08ENZ0