Fujitsu ETERNUS DX8000 series 구성 매뉴얼 - 페이지 8

{카테고리_이름} Fujitsu ETERNUS DX8000 series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX8000 series 17 페이지.

페이지 인쇄

Chapter 2

ETERNUS DX Connection Settings

2.1

Common Settings

This section explains the settings required for all server OSs, regardless of the connection configuration. For

details of how to use ETERNUSmgr to perform these settings, refer to the "ETERNUSmgr User Guide".

2.1.1

Setting the To-server Connection Type (Setting the CA Parameters)

For each connection configuration, perform the following iSCSI port parameter settings only. All other

parameters should be left on their default values.

Table 2.1

TCP/IP Setting

IP Address

Subnet Mask

Gateway

iSNS Server

iSCSI Settings

iSCSI Name

Alias Name

Security

CHAP

User Name

New Password

New Password (Re-enter)

General Settings

Affinity Mode

Host Affinity

Host Response

CA parameter settings (iSCSI port settings)

Parameter

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

Solaris OS, HP-UX, Windows®, Linux, VMware ESX, Oracle VM Server

Arbitrary

Select "ON" to use the iSNS server, and specify the IP address for the iSNS

server.

Arbitrary

Caution:

When configuring multipaths, specify a different name for each iSCSI port.

If the same iSCSI name is specified for multiple ports, connection via

multipaths may not be available.

Arbitrary

OFF (Default value): When both unidirectional CHAP authentication and

bidirectional CHAP authentication are not used

ON: When either unidirectional CHAP authentication or bidirectional CHAP

authentication is used

When using bidirectional CHAP authentication, set a password.

When using unidirectional CHAP authentication, a CHAP user name and

password do not need to be set.

OFF (Default value): When not using Affinity Mode

ON: When using Affinity Mode

Not available ( When "Host Affinity" is set to "ON")

P3AM-3972-08ENZ0