Fujitsu ETERNUS LT260 사용자 설명서 - 페이지 23
{카테고리_이름} Fujitsu ETERNUS LT260에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS LT260 44 페이지. Tape library
Fujitsu ETERNUS LT260에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (5 페이지)
페이지 인쇄
Chapter 2 LT260 Installation
2.2 Installation Area
■
For the rack having 9x9mm corner holes
For the rack having 6.8mm round holes
Two screws and washers are used respectively and four rack rail adaptors are installed in the prop of the rack.
Figure 2.6 Mount rack rails (2)
6
5
4
(2)
6U
3
2
1
(1)
(3)
*Prop of the rack (front)
*The putting position is common in both corner holes and round holes.
•
When the installation of the washer shakes by the shape of the rack prop, the washer is available even if
it does not use it.
•
When the installation hole of the rack is a round hole geometry, the washer is available even if it does
not use it.
•
Even if the position where the screw at position (2) is installed changes into the place of (3), it is
acceptable.
FUJITSU Storage ETERNUS LT260 Tape Library User's Guide -Site Planning-
For main body of device fixation
Rack rail (Base / Expansion)
Rack rail adapter
23
Copyright 2018 FUJITSU LIMITED
6
Screw
5
Washer
4
6U
3
2
1
Prop of the rack (rear)
P3AM-8782-06ENZ0