Fujitsu ETERNUS LT260 Kullanıcı Kılavuzu - Sayfa 23
Depolama Fujitsu ETERNUS LT260 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Fujitsu ETERNUS LT260 44 sayfaları. Tape library
Ayrıca Fujitsu ETERNUS LT260 için: Hızlı Başlangıç Kılavuzu (5 sayfalar)
Sayfayı Yazdır
Chapter 2 LT260 Installation
2.2 Installation Area
■
For the rack having 9x9mm corner holes
For the rack having 6.8mm round holes
Two screws and washers are used respectively and four rack rail adaptors are installed in the prop of the rack.
Figure 2.6 Mount rack rails (2)
6
5
4
(2)
6U
3
2
1
(1)
(3)
*Prop of the rack (front)
*The putting position is common in both corner holes and round holes.
•
When the installation of the washer shakes by the shape of the rack prop, the washer is available even if
it does not use it.
•
When the installation hole of the rack is a round hole geometry, the washer is available even if it does
not use it.
•
Even if the position where the screw at position (2) is installed changes into the place of (3), it is
acceptable.
FUJITSU Storage ETERNUS LT260 Tape Library User's Guide -Site Planning-
For main body of device fixation
Rack rail (Base / Expansion)
Rack rail adapter
23
Copyright 2018 FUJITSU LIMITED
6
Screw
5
Washer
4
6U
3
2
1
Prop of the rack (rear)
P3AM-8782-06ENZ0