Brother MFC-9440CN 빠른 시작 매뉴얼 - 페이지 10

{카테고리_이름} Brother MFC-9440CN에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother MFC-9440CN 10 페이지. Facsimile equipment
Brother MFC-9440CN에 대해서도 마찬가지입니다: 브로셔 및 사양 (6 페이지), 빠른 설정 매뉴얼 (34 페이지), 매뉴얼 (7 페이지), 부품 참조 목록 (43 페이지), 청소 및 관리 (7 페이지), 빠른 설정 매뉴얼 (34 페이지)

페이지 인쇄
Brother MFC-9440CN 빠른 시작 매뉴얼
DCP9040CN, DCP9045CDN, MFC9440CN & MFC9840CDW
a. Remove the screwdriver (or other object) used to hold the cam in figure 1.
b. Pushing the roller holder assembly fully to the top of the machine should cause the cam to move
forward. The roller holder assembly should remain locked in the UP position.
c. Pushing the cam toward the back of the machine should cause the roller holder assembly to drop.
The cam should remain in this position.
d. If this behavior is observed, the repair is successful. Secure the frame assembly with the three
screws removed in figure 6. Proceed with reassembly of the machine. LEAVE THE CAM
ASSEMBLY PUSHED TOWARDS THE REAR OF THE MACHINE.
e. If the machine does NOT behave as described, the lift arm is not in the correct position. Repeat the
procedure, beginning with step 5. IT IS NOT NESSCARY TO COMPLETELY REMOVE THE
ASSEMBLY FROM THE MACHINE – SIMPLY SLIDE IT TO THE RIGHT.
Note: Check the bush 7 holder, to make sure it is installed properly and did not clip off.
11. Now you can finish reassembling the machine in reverse order.
NO PAPER FEED Message, Clicking Noise
March 3, 2008
The Bush 7 is not clipped on properly.
The Bush 7 is clipped on properly.
Page 10 of 10
SERVICE
UPDATE No.
F1249