Brother MFC-9440CN 빠른 시작 매뉴얼

{카테고리_이름} Brother MFC-9440CN에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother MFC-9440CN 10 페이지. Facsimile equipment
Brother MFC-9440CN에 대해서도 마찬가지입니다: 브로셔 및 사양 (6 페이지), 빠른 설정 매뉴얼 (34 페이지), 매뉴얼 (7 페이지), 부품 참조 목록 (43 페이지), 청소 및 관리 (7 페이지), 빠른 설정 매뉴얼 (34 페이지)

페이지 인쇄
Brother MFC-9440CN 빠른 시작 매뉴얼
DCP9040CN, DCP9045CDN, MFC9440CN & MFC9840CDW
IMPORTANT! READ THIS PROCEDURE IN ITS ENTIRETY BEFORE ATTEMPTING THE PROCEDURE.
UNSUCCESSFUL REPAIR OR DAMAGE MAY RESULT FROM IMPROPER INSTALLATION.
Symptom:
Customer reports a "NO PAPER FED" message when attempting to feed paper from cassette and/or hears a
"popping" noise when attempting to feed paper and the paper does not leave the paper tray.
Possible cause:
The paper (PE) actuator is stuck in the wrong position and or there is damage to the paper feed frame unit.
PE Actuator is in the
Recommendation:
Replace the paper feed frame unit.
PAPER FEED FRAME ASSEMBLY – REMOVAL
Remove the consumables:
1. Power off the machine and disconnect the power cord. Remove the paper tray from the machine.
2. Open the front door. Remove the drum/toners, belt unit and the waste toner pack (both located under the
drum unit). Important – place the drum unit on a flat surface and protect the drum unit from excessive
bright light.
Remove the outer covers:
1. Remove the two screws securing the back cover. Remove the back cover.
NO PAPER FEED Message, Clicking Noise
March 3, 2008
No paper fed
noise.wav
incorrect
position
Page 1 of 10
SERVICE
UPDATE No.
PE Actuator is in the
correct
position
F1249