Brother 2 매뉴얼 - 페이지 24

{카테고리_이름} Brother 2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother 2 39 페이지. Hewlett-packard laser printer user guide
Brother 2에 대해서도 마찬가지입니다: 사용자 설명서 (15 페이지)

페이지 인쇄

Continuous Cutting

After cutting a pattern, you can continue to cut either the same

pattern or a different pattern without cutting off the material.

Note

• The maximum length (in the feeding direction) of the

material that can be cut after loading is 1,776 mm (69.9")*.

When cutting material longer than the specified length, cut

off the material and feed it out, and then insert the material

again to continue cutting.

* This depends on the material and operating conditions

specified by Brother.

■ Repeatedly Cutting the Same Pattern

Touch "Continue to cut".



The preview screen appears.

Select "Cut" in the preview screen, and then touch the

"Start" key to start cutting.



The pattern that is displayed is cut.



Cutting start from the bottom edge of the last pattern that was

cut.

Memo

• To change the cutting start position, see "Changing the

Cutting Start Position" on page 22.

• The cutting start position can also be adjusted by adding

space at the beginning of the cutting data while it is being

created. For details, see "Creating Cutting Data" on

page 5.

■ Continuing To Cut With a Different Pattern

Touch "Continue to cut".



The preview screen appears.

Touch

in the preview screen.



When

is touched, the message "OK to delete data

showing on the screen?" appears.

Touch the "OK" key.

Select "Start to cut rolled material", and then retrieve a

different pattern.

• For details, see "Retrieving Data on the Machine" on page 16.