Brother HL-730PLUS 빠른 설정 매뉴얼 - 페이지 11
{카테고리_이름} Brother HL-730PLUS에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother HL-730PLUS 17 페이지. Quick setup guide - english
Brother HL-730PLUS에 대해서도 마찬가지입니다: 운영 매뉴얼 (25 페이지)
English: HL-YL Quick Setup Guide, Body
Action 6-2: Prepare Windows 3.1 for the Printer
Setting Up Windows 3.1 for the Printer
You need to configure Windows 3.1 for the printer by installing the printer driver and
TrueType-compatible fonts from the supplied disk into Windows 3.1.
Because the supplied printer driver and fonts are compressed on the disk, be sure to use the
supplied installer program to install them. These instructions assume you will install the
driver and fonts from the disk drive A.
1. Start Windows 3.1.
2. Insert the supplied disk for Windows into your floppy disk drive.
3. Choose Run from the File menu in the Program Manager.
4. Type the drive name where you inserted
the supplied disk and "SETUP" in the
box: for example, A:\SETUP. Click the
OK button or press the Enter key.
5. The installer program will begin. Follow the instructions on the computer screen.
(Be sure to restart Windows when the installation process is completed.)
NOTE
The installer automatically updates your SYSTEM.INI Windows file by adding
DEVICE=bi-di.386 under the [386Enh] section. If any bi-directional parallel
communications device driver has previously been installed, it will be deactivated by this
new driver. If you want to use the driver that was previously installed, you should re-install
your previous driver. However, re-installing the previous driver will make the HL-700
series driver inactive.
The installer makes the installed printer driver the Windows default.
The installer automatically sets the printer port to the parallel interface, LPT1.
During this installation, changes have been made to the SYSTEM.INI file. It is necessary
to restart Windows so that the changes become effective and the installed bi-directional
parallel communications device driver can take effect.
10