Fujitsu PRIMERGY LTO2 사용자 설명서 - 페이지 23
{카테고리_이름} Fujitsu PRIMERGY LTO2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY LTO2 28 페이지. Half-height sas tape drive
페이지 인쇄The meaning of different patterns of LEDs is as follows:
Table 2 Clean, Tape, Drive and Ready LED sequences
LED Sequence
All LEDs OFF.
Ready and Clean OFF. Drive
and Tape FLASH.
Ready is ON.
Ready FLASHES.
Ready FLASHES- steady ON-
FLASHES.
Ready FLASHES fast.
Ready is OFF, others are
ON.
Clean FLASHES.
Cause
Drive may not have power,
may be faulty or may have
been power cycled or reset
during a firmware upgrade.
The drive has failed to execute
power-on self test (POST).
The drive is ready for opera-
tion.
The drive is carrying out a nor-
mal activity (read, write).
The drive is in OBDR mode.
This mode is not supported by
Fujitsu.
The drive is downloading firm-
ware.
Firmware is being repro-
grammed.
The drive requires cleaning.
Action required
Make sure the drive is switched on. The power
on/off switch on an external drive
incorporates a green LED.
Check the power cord connection and replace
the cable if necessary. On external drives,
you can use the power cord from your monitor
or another device to check that the connection
is working.
If the power supply is present and all LEDs
remain off, power cycle or reset the drive . If
it still fails, call for service.
Power cycle or reset the drive.
If the error condition reappears, call for
service.
None. This is normal.
None.
If the drive is upgrading firmware, do not reset
or power cycle it.
To leave OBDR mode, power cycle the tape
drive.
None.
Do not reset or power cycle the drive.
None.
Do not reset or power cycle the drive.
Load the Ultrium cleaning cartridge. See
"Cleaning
cartridges" on page 17 for
supported cartridges and instructions.
If the Clean LED is still flashing when you load
a new or known good data cartridge after
cleaning, call for service.
LTO-2 Half-Height SAS Tape Drives
23