Fujitsu PRIMERGY LTO2 User Manual - Page 23

Browse online or download pdf User Manual for Storage Fujitsu PRIMERGY LTO2. Fujitsu PRIMERGY LTO2 28 pages. Half-height sas tape drive

Print Page

The meaning of different patterns of LEDs is as follows:

Table 2 Clean, Tape, Drive and Ready LED sequences

LED Sequence

All LEDs OFF.

Ready and Clean OFF. Drive

and Tape FLASH.

Ready is ON.

Ready FLASHES.

Ready FLASHES- steady ON-

FLASHES.

Ready FLASHES fast.

Ready is OFF, others are

ON.

Clean FLASHES.

Cause

Drive may not have power,

may be faulty or may have

been power cycled or reset

during a firmware upgrade.

The drive has failed to execute

power-on self test (POST).

The drive is ready for opera-

tion.

The drive is carrying out a nor-

mal activity (read, write).

The drive is in OBDR mode.

This mode is not supported by

Fujitsu.

The drive is downloading firm-

ware.

Firmware is being repro-

grammed.

The drive requires cleaning.

Action required

Make sure the drive is switched on. The power

on/off switch on an external drive

incorporates a green LED.

Check the power cord connection and replace

the cable if necessary. On external drives,

you can use the power cord from your monitor

or another device to check that the connection

is working.

If the power supply is present and all LEDs

remain off, power cycle or reset the drive . If

it still fails, call for service.

Power cycle or reset the drive.

If the error condition reappears, call for

service.

None. This is normal.

None.

If the drive is upgrading firmware, do not reset

or power cycle it.

To leave OBDR mode, power cycle the tape

drive.

None.

Do not reset or power cycle the drive.

None.

Do not reset or power cycle the drive.

Load the Ultrium cleaning cartridge. See

"Cleaning

cartridges" on page 17 for

supported cartridges and instructions.

If the Clean LED is still flashing when you load

a new or known good data cartridge after

cleaning, call for service.

LTO-2 Half-Height SAS Tape Drives