Fujitsu PRIMERGY SX910 S1 운영 매뉴얼 - 페이지 27

{카테고리_이름} Fujitsu PRIMERGY SX910 S1에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY SX910 S1 46 페이지. Storage blade

Installing the dummy module

Slide the dummy module with the release lever down into the empty slot until it

clicks into place.

Installing the storage blade

The PRIMERGY SX910 S1 storage blade can be installed during operation and

is recognized by the management blade. You must restart the related server

blade to enable the storage blade to communicate with the server blade, see the

section

"Putting the Storage Blade into operation" on page

CAUTION!

Follow the safety instructions and information in section

sensitive device label" on page

Figure 5: Unlocking and installing the storage blade

Make sure the storage blade is installed the correct way round. The

control panel must be in the area at the top.

Ê Undo the locking mechanism (1) of the release lever.

SX910 S1

Operating Manual

Installing/removing a Storage Blade

17.

41.

"Electrostatic