AEG OKO-SANTO 2842-6 i 작동 및 설치 지침 - 페이지 7

{카테고리_이름} AEG OKO-SANTO 2842-6 i에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG OKO-SANTO 2842-6 i 14 페이지. Integrating fridge freezer
AEG OKO-SANTO 2842-6 i에 대해서도 마찬가지입니다: 작동 및 설치 지침 (28 페이지)

페이지 인쇄

Instructions for building-in

Apply joint the sealing strip as

shown in figure.

Push appliance into the hous-

ing until stop strip (A) touches

the kitchen unit.

Open the door and push the

appliance against the side of

the kitchen unit opposite to that

of appliance hinges.

Fasten the appliance with 4

screws provided in the kit

included with the appliance.

Snap vent grille (C) and hinge

cover (D) into position.

D765

D023

D723

Starting up and temperature regulation

Wash the inside of the appliance with lukewarm water with a little

bicarbonate of soda added (5ml to 0,5 litre of water). Do not use soap

or detergent as the smell may linger. Dry the appliance thoroughly.

• When the refrigerator compartment door is opened, the internal ligh-

ting is switched on. The temperature selector knob is located on the

RH side of the refrigerator compartment.

Setting "0": Off.

Setting "1": Hightest temperature, (warmest setting).

Setting "6" (end-stop) : Lowest temperature, (coldest setting).

The exact setting should be chosen keeping in mind that the tempe-

rature inside the refrigerator depends on:

-the quantity of food stored

-how often the door is opened

The temperatures in the refrigerator compartment and freezer com-

partment cannot be independently regulated.

If you want to freeze fresh food rapidly, select setting "6", ensuring that

the temperature in the refrigerator compartment does not drop below

0°C. You should also promptly reset the temperature regulator to set-

ting "3" or "4", if this occurs.

Important!

High ambient temperatures (e.g. on hot summer days) and a cold set-

ting on the temperature regulator (position"5" to "6") can cause the

compressor to run continuously.

If this happens, turn the temperature regulator back to a warmer set-

ting (position "3" to "4"). At this setting the compressor will be switched

on and off as usual and automatic defrosting recommenced.

Ambient Temperature switch

With a room temperature

below +16°C the Fridge free-

zer may not function correctly.

If the room temperature is

lower than +16°C it will be

necessary to depress switch

(A). The relevant pilot light

comes on.

D710