AEG OKO-SANTO 2842-6 i Operating And Installation Instructions - Page 7
Browse online or download pdf Operating And Installation Instructions for Refrigerator AEG OKO-SANTO 2842-6 i. AEG OKO-SANTO 2842-6 i 14 pages. Integrating fridge freezer
Also for AEG OKO-SANTO 2842-6 i: Operating And Installation Instructions (28 pages)
Print Page
Instructions for building-in
Apply joint the sealing strip as
shown in figure.
Push appliance into the hous-
ing until stop strip (A) touches
the kitchen unit.
Open the door and push the
appliance against the side of
the kitchen unit opposite to that
of appliance hinges.
Fasten the appliance with 4
screws provided in the kit
included with the appliance.
Snap vent grille (C) and hinge
cover (D) into position.
22
D765
A
D023
D
C
D723
Starting up and temperature regulation
Wash the inside of the appliance with lukewarm water with a little
bicarbonate of soda added (5ml to 0,5 litre of water). Do not use soap
or detergent as the smell may linger. Dry the appliance thoroughly.
• When the refrigerator compartment door is opened, the internal ligh-
ting is switched on. The temperature selector knob is located on the
RH side of the refrigerator compartment.
Setting "0": Off.
Setting "1": Hightest temperature, (warmest setting).
Setting "6" (end-stop) : Lowest temperature, (coldest setting).
The exact setting should be chosen keeping in mind that the tempe-
rature inside the refrigerator depends on:
-the quantity of food stored
-how often the door is opened
The temperatures in the refrigerator compartment and freezer com-
partment cannot be independently regulated.
If you want to freeze fresh food rapidly, select setting "6", ensuring that
the temperature in the refrigerator compartment does not drop below
0°C. You should also promptly reset the temperature regulator to set-
ting "3" or "4", if this occurs.
Important!
High ambient temperatures (e.g. on hot summer days) and a cold set-
ting on the temperature regulator (position"5" to "6") can cause the
compressor to run continuously.
If this happens, turn the temperature regulator back to a warmer set-
ting (position "3" to "4"). At this setting the compressor will be switched
on and off as usual and automatic defrosting recommenced.
Ambient Temperature switch
With a room temperature
below +16°C the Fridge free-
zer may not function correctly.
If the room temperature is
lower than +16°C it will be
necessary to depress switch
(A). The relevant pilot light
comes on.
A
D710
7