Brother MFC-440CN 빠른 설정 매뉴얼 - 페이지 23

{카테고리_이름} Brother MFC-440CN에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother MFC-440CN 34 페이지. Quick setup guide - english
Brother MFC-440CN에 대해서도 마찬가지입니다: 서비스 매뉴얼 (5 페이지), 설정 매뉴얼 (23 페이지), 빠른 설정 매뉴얼 (35 페이지), 서비스 매뉴얼 (17 페이지)

Brother MFC-440CN 빠른 설정 매뉴얼
Installing the Driver & Software
15
If the machine is configured for your network,
choose the machine from the list, and then click
Next.
Note
This window will not appear if there is only one
machine connected on the network, it will be
chosen automatically.
16
If the machine is not yet configured for use on
your network, the following screen appears.
Click OK.
The Configure IP Address window will
appear. Enter an IP address for your machine
that is suitable for your network by following the
on-screen instructions.
17
When the Brother and ScanSoft On-Line
Registration screen is displayed, make your
selection and follow the on-screen instructions.
18
Click Finish to restart your computer.
®
(For Windows
2000 Professional/XP/XP
Professional x64 Edition, you must be logged
on with Administrator rights.)
Note
• After restarting the computer, the Installation
Diagnostics will run automatically. If the
installation is unsuccessful, the installation results
window will be shown. If the Diagnostics shows a
failure, please follow the on-screen instructions or
read the on-line help and FAQ's in
Start/All Programs (Programs)/Brother/
MFC-XXXX.
• Once you are sure that you can print after the
installation, restart your Firewall software.
• Firewall settings on your PC may reject the
necessary network connection for Network
Scanning and PC-Fax.
Follow the instructions below to configure your
Windows Firewall. If you are using a personal
Firewall software, see the User's Guide for your
software or contact the software manufacturer.
®
• For Windows
XP SP2 users:
1 Click the Start button, Control Panel and then
Windows Firewall.
Make sure that Windows Firewall on the
General tab is set to On.
2 Click the Advanced tab and Settings... button.
3 Click the Add button.
4 Add port 54925 for network scanning, enter the
information below:
1) (Any description)
2) Localhost
3) 54925
4) 54925
5) Select UDP
Then, click OK.
1
2
3
4
5 Click the Add button.
Windows
5
21
®