Fujitsu fi-5530C - Document Scanner 시작하기 - 페이지 24

{카테고리_이름} Fujitsu fi-5530C - Document Scanner에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu fi-5530C - Document Scanner 28 페이지. Color departmental scanner
Fujitsu fi-5530C - Document Scanner에 대해서도 마찬가지입니다: 설치 절차 매뉴얼 (7 페이지), 설치 절차 매뉴얼 (9 페이지), 설치 절차 (3 페이지), 시작하기 (28 페이지), 브로셔 및 사양 (2 페이지), 사양 (2 페이지), 소모품 교체 및 청소 지침 (14 페이지), 청소 지침 매뉴얼 (13 페이지), 사용 설명서 (10 페이지)

페이지 인쇄

Fujitsu fi-5530C - Document Scanner 시작하기

Symptom

Paper is not fed (pick error

occurs frequently, or docu-

ment stops midway).

The generated images are

elongated.

There is a shadow on the

leading edge of the gener-

ated image?

AP-2

Check this item

Do the documents satisfy the "Docu-

ment Quality" and the "Multi feed

Detection Conditions" in the chapter 6

of the fi-5530C Operator's Guide?

Is the Pick roller dirty?

Is the Pick roller worn out?

Is there any debris on the document feed

path?

Are the Feed rollers dirty?

Have you adjusted the scan scale?

Are the Feed rollers dirty?

Have you adjusted the offset (the scan-

ning starting position)?

Remedy

Use the documents that satisfy the "Document

Quality" and the "Multi feed Detection Condi-

tions" in the chapter 6 of the fi-5530C Operator's

Guide.

Clean the Pick roller. Refer to the Operator's

Guide "3.2. Cleaning the ADF".

Clean the Pick roller. Refer to the Operator's

Guide "4.3. Replacing the Pick Roller".

Remove any debris from the document feed path.

Clean the Feed rollers. Refer to the Operator's

Guide "3.2. Cleaning the ADF".

For Windows 98, Windows Me, Windows 2000,

WindowsXP, select "Scanners and Cameras" in

the control panel, then click the [Device Set] tab

to adjust scale.

For Windows 95, Windows NT 4.0, right click the

Scanner Control Center in the task tray, select

[Options] and adjust the scan scale.

Clean the Feed rollers. Refer to the Operator's

Guide "3.2. Cleaning the ADF".

For Windows 98, Windows Me, Windows 2000,

WindowsXP, adjust the [Sub-scan Setting] on

[Scanners and Cameras] in the control panel.

For Windows 95, Windows NT 4.0, right click the

Scanner Control Center, select [Options]-[Sub-

scan Setting] and adjust the offset.