Fujitsu Fi-718PR 운영자 매뉴얼 - 페이지 5

{카테고리_이름} Fujitsu Fi-718PR에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Fi-718PR 17 페이지. Imprinter
Fujitsu Fi-718PR에 대해서도 마찬가지입니다: 운영자 매뉴얼 (18 페이지)

페이지 인쇄
Fujitsu Fi-718PR 운영자 매뉴얼

2. Installation

2.1. Installing the Imprinter

Install the imprinter in the following procedure.
1.
Turn off the scanner, and disconnect the power
cable.
2.
Remove the stacker from the scanner as shown
below.
1) Hold the left side of the stacker with your left hand.
About 80 degrees
2) Gently pull the stacker as you push against the scanner
with your thumb.
1
Push against the scanner with your thumb.
2
Carefully pull the stacker out.
3) Once the left arm of the stacker has been released from the
scanner, remove the right arm.
ATTENTION
You must remove the stacker before installing the imprinter.
Stacker
3.
Install the scanner onto the imprinter.
Holding the scanner above the rear side of the imprinter,
gently mount the scanner onto the imprinter while lowering it
forward until it makes contact with the imprinter.
ATTENTION
Be careful not to have your fingers caught.
After installation
4.
Raise the locks (x2) on the back of the scanner.
fi-718PR Imprinter Operator's Guide | 3
Lock