Brother PE-DESIGN Ver.8.0 설치 매뉴얼 - 페이지 8

{카테고리_이름} Brother PE-DESIGN Ver.8.0에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother PE-DESIGN Ver.8.0 16 페이지. Personal embroidery design software system

페이지 인쇄

[STEP1] Installing the Software

This section describes how to install the application software.

Note:

• If the installation is interrupted or not performed as described, the software will not be installed

correctly.

• Before turning on the computer, be sure that the USB card writer module is DISCONNECTED.

• In order to install the software, you must log on to the computer using an account with administrator

privileges. If you are not logged on with the Administrator account, the password for the

Administrator account (Administrators) may be requested with Windows

to continue the procedure.

Insert the enclosed CD-ROM into the computer's CD-ROM drive.

Windows

→ After a short while, the language selection dialog box for InstallShield Wizard automatically appears.

Continue with step

Memo:

If the installer does not automatically start up:

1) Click the Start button.

2) Click Run.

→ The Run dialog box appears.

3) Type in the full path to the installer, and then click OK to start up the installer.

For example: D:\setup.exe (where "D:" is the name of the CD-ROM drive)

XP users only

on page 8.

Before Use

7. Type in the password