Brother Quattro 2 6700D 운영 매뉴얼 - 페이지 15

{카테고리_이름} Brother Quattro 2 6700D에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother Quattro 2 6700D 16 페이지. Kit para crear efectos decorativos con bobinas
Brother Quattro 2 6700D에 대해서도 마찬가지입니다: 운영 매뉴얼 (50 페이지), 사용 설명서 (40 페이지), (영어) 사용 설명서 (16 페이지)

페이지 인쇄

TROUBLESHOOTING

Several solutions for minor problems are described below. If the problem persists, contact your nearest authorized

dealer.

■ The thread was accidentally cut

automatically and the bobbin thread is

caught inside the machine (Only for

machines equipped with the automatic

thread cutting function)

Cut the thread near the fabric above the

needle plate, and then remove the fabric.

Thread

Remove the bobbin, and then hold it out

toward the left side of the machine.

Lower the presser foot.

Press the "Thread Cutter" button again, and

then pull the thread out to the left while the

thread cutter is operating.

CAUTION

• Do not pull on the thread with excessive force,

otherwise the machine may be damaged.

■ The pattern is misaligned

Refer to "ADJUSTING THE THREAD TENSION" and

increase the upper thread tension. If the pattern is still

misaligned, reduce the tension of the bobbin thread.

Example: Decorative Stitch

Correct tension

The upper thread tension is too loose, or the bobbin

thread tension is too tight.

■ The bobbin thread catches on the tension

spring of the bobbin case

Sew with no tension applied to the bobbin thread.

(Refer to "When tension is not applied to the bobbin

thread" on page 6.)