Fujitsu ScanSnap iX100 매뉴얼 - 페이지 10

{카테고리_이름} Fujitsu ScanSnap iX100에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ScanSnap iX100 17 페이지.
Fujitsu ScanSnap iX100에 대해서도 마찬가지입니다: 연결 매뉴얼 (12 페이지), 시작하기 (2 페이지)

페이지 인쇄

 The ScanSnap can be charged while it is being used. Although the

following symptoms may occur during a charge, it does not affect the

ScanSnap in any way.

It takes a long time to complete a charge

The remaining battery power is reduced and charging is not

completed

The ScanSnap is automatically turned off during a scan

■Battery

 The battery is not fully charged when you purchase the ScanSnap.

Charge the ScanSnap before using it.

 Even though the battery gets warm while the ScanSnap is used or

charged, it is normal. You can continue to use the ScanSnap.

However, if the battery becomes high in temperature and the internal

temperature of the ScanSnap exceeds the allowable use or charge

range, the [Scan/Stop] button flashes orange and the ScanSnap may

turn off automatically. In this case, stop using or charging the

ScanSnap and wait until the temperature falls into the allowable

range.

 The battery life varies depending on the condition of use or the

deterioration of the battery.

 The battery is a consumable part.

With every charge, the battery life is shortened.

When a fully charged battery runs out too quickly, the battery

may be in a deteriorated state. In this case, contact your

FUJITSU scanner dealer or an authorized FUJITSU scanner

service provider.

 When storing the ScanSnap, keep in mind the following in order to

prevent the battery from deteriorating.

It is recommended that the remaining battery power is adjusted

to the suitable level for storage (approximately 40 to 50%).

Storing the ScanSnap in a cool and dry place is recommended.

When storing away the ScanSnap for a while, charge the battery

every six months to keep the remaining battery power to

approximately 40 to 50%.