Fujitsu ScanSnap iX100 매뉴얼 - 페이지 8
{카테고리_이름} Fujitsu ScanSnap iX100에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ScanSnap iX100 17 페이지.
Fujitsu ScanSnap iX100에 대해서도 마찬가지입니다: 연결 매뉴얼 (12 페이지), 시작하기 (2 페이지)
페이지 인쇄
Do not use the ScanSnap immediately after moving it from a cold
place into a warm room.
Condensation may occur, which might cause problems. Let the
ScanSnap dry for one or two hours before you use it.
When handling documents or an optional Carrier Sheet, be careful
not to cut your fingers with them.
Do not use a damaged optional Carrier Sheet because it may
damage or cause the scanner to malfunction.
When carrying the ScanSnap outside while it is raining or snowing,
pay special attention so that the ScanSnap does not get wet. Not
doing so might cause problems.
If the ScanSnap gets wet, wipe it or wait until it dries.
Do not use any aerosol sprays or alcohol based sprays to clean
the ScanSnap. Dust blown up by strong air from the spray may
enter the inside of the ScanSnap. This may cause the ScanSnap
to fail or malfunction. Sparks, caused by static electricity,
generated when blowing off dust and dirt from the outside of the
ScanSnap may cause a fire.
LED light source of this product is not exposed in normal use, and
the intensity of LED light emission does not pose any risk of eye
damage. Do not take apart, repair, or customize the ScanSnap.
Direct exposure to the LED light source could cause problems with
visual acuity.
Check the following items once a month. Regular checks help
early detection of abnormalities or failures.
No battery leakage occurs from the battery.
The USB cable is not emitting abnormal heat, or the cable is not
rusty or bent.
Dust has not accumulated on the USB cable. If so, wipe off any
dust with a soft, dry cloth.
The USB cable does not have any cracks or scratches.
8