Fujitsu PenCentra 130 사용자 지침 - 페이지 2
{카테고리_이름} Fujitsu PenCentra 130에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PenCentra 130 2 페이지. Hd portable accessories
Fujitsu PenCentra 130에 대해서도 마찬가지입니다: 사용자 설명서 (2 페이지), 사용자 설명서 (8 페이지), 설치 지침 (1 페이지), 사용자 설명서 (2 페이지), 사용자 지침 (1 페이지), 사용자 지침 (1 페이지), 사용자 지침 (1 페이지), 데이터시트 (3 페이지)
페이지 인쇄
2. For installation on the harsh environment case
(HEC), remove the edge from the screen protector,
as shown in Figure 4.
Figure 4. Removing Screen Protector Edge Strip
3. Peel the protective film from the adhesive side of
screen protector as shown in Figure 5.
Figure 5. Removing Adhesive Backing
4. Apply the screen protector with the adhesive side
down and the notch in the lower left corner as
shown in Figure 6. Apply pressure along the edges
of the screen protector with your finger. (Avoid
lifting the screen protector from the display
window after it is installed. The adhesive requires
48 hours to cure completely.
Figure 6. Applying the Screen Protector
2 of 2
5. Remove the protective film from the top surface of
the screen protector as shown in Figure 7.
Figure 7. Peeling the Protective Film
6. Wipe the exposed surface of the screen protector
with a clean dry cloth to remove any tacky residue
left behind by the protective film. If necessary, clean
the surface of the HEC window with a soft cotton
cloth dampened with denatured alcohol to remove
the residue.
Using the carrying strap and hand straps
The carrying strap assembly can be attached to either
end of the HEC, depending upon your preference.
Attach the clips to either the left or right set of
d-rings.
One or both of the two elasticized handstraps can be
used. Slide your hand between one or both straps
(whichever is most comfortable) and the HEC.
D-rings (one of four)
Figure 8. HEC Handstrap Assembly
Handstraps
58-0671-00B
0