Fujitsu Point 1600 사용자 설명서 - 페이지 36

{카테고리_이름} Fujitsu Point 1600에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Point 1600 48 페이지. Pen tablet
Fujitsu Point 1600에 대해서도 마찬가지입니다: 제품 참조 (2 페이지)

페이지 인쇄

Calibrating the Pen

If the cursor does not appear under the tip of the pen or appears to be misaligned with

the pen tip, you should calibrate the pen. The pen tablet determines where the pen tip

touches the display screen in order to determine the correct location of the cursor.

Calibrating the pen may be necessary to accurately align the cursor with the actual

position of the pen tip in the following situations:

• The previous user of the pen tablet writes with the opposite hand and has

calibrated the pen tablet.

• The Point 1600 pen tablet has been in use for some time without being recalibrated.

• The screen has been rotated from landscape (wide) to portrait (tall) orientation, or

from portrait to landscape orientation. (Note that rotating the screen does not

affect pen calibration, however, changing the screen orientation may cause you to

hold the pen tablet and pen in a slightly different position.)

To calibrate the pen:

1. From the Start menu, choose Settings, then choose Control Panel. Double-tap the

Pen Configuration icon. Tap the Calibration tab. On the Calibration property sheet,

tap the Pen Calibration button. Instructions for calibrating the pen are displayed.

Note that if the pen is too far out of calibration, you cannot perform the pen

calibration procedure. In this is the case, the system prompts you to restore default

calibration settings. Tap the Default Calibration button. You can calibrate the pen

after default settings are restored.

2. Position the pen tablet as you normally do during use. (Hold the pen at the angle

that you regularly use.)

Ensure that you touch only the screen with the tip of the pen during the calibration

procedure. Touching your hand or any object other than the pen tip on the screen

will cause inaccurate pen calibration.

3. Perform the calibration steps according to the instructions on the screen. The

calibration utility displays a cross-hair symbol in each corner of the screen, one

corner at a time. Hold the pen as you normally do while using the system and, as

accurately as possible, tap the center of each cross-hair as it is displayed.

3-4

Care, Maintenance, and Troubleshooting