Fujitsu Stylistic 3400 조립 및 사용 지침 - 페이지 2

{카테고리_이름} Fujitsu Stylistic 3400에 대한 조립 및 사용 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Stylistic 3400 4 페이지. Wall-mount cradle
Fujitsu Stylistic 3400에 대해서도 마찬가지입니다: 사용자 설명서 (3 페이지), 설치 매뉴얼 (4 페이지), 사용자 설명서 (2 페이지), 운영 지침 (1 페이지), 설치 및 사용자 설명서 (8 페이지), 설치 매뉴얼 (1 페이지)

페이지 인쇄

3. Using the four black Phillips screws (with star

lockwashers), secure the cradle to the back

assembly.

4. Secure the circuit card to the two standoffs,

using the two silver screws and the two

washers, with the washers positioned between

the screws and the circuit card (reference

Figure 2).

Figure 2. Mounting the Circuit Card

Installing the keyboard

5. Remove the adhesive backing from the Velcro

strips that are attached to the tray.

6. Carefully position the keyboard over the strips

so that the bottom edge of the keyboard butts

against the lower lip of the tray. Once it is

positioned properly, firmly press the keyboard

onto the Velcro strips to secure it (reference

Figure 3).

Back Assembly

Tiedown #1 (approximate location)

Cradle

Figure 3. Wall Mount Components

4/00

Mounting

Hardware

Circuit Card

Cables

Circuit Card

Velcro

Keyboard

Strips

Tray Assembly

Screw Holes (6 ea.: two on

each side, two on bottom)

Page 2 of 4

7. Route the coiled keyboard cable over the

vertical edge of the tray assembly. Leave

approximately ten coils on the keyboard side

(reference Figure 4)

8. Stretch the coil over the edge of the tray so the

section of cable from the edge of the tray to the

first tie point is uncoiled (reference Figure 4).

9. Tie down the cable at the first tie point using a

Ty-Wrap from the hardware kit. The tie point

is located just below the top edge of the tray

(reference Figure 3 for approximate location).

Clip any excess Ty-Wrap with the cutting

pliers.

10. Plug the keyboard plug into the jack on the

circuit card.

Tiedown Point #2

Tiedown Point #1

Uncoiled length

Coils on Keyboard

Side of Tray

(approximately ten)

Figure 4. Routing the Keyboard Cable

11. Secure the remaining coil to the second

tiedown using a Ty-Wrap from the hardware

kit. Clip any excess Ty-Wrap with the cutting

pliers.

Installing the AC Adapter

12. Locate the Velcro strip on the right-hand side

of the tray. This is the location at which the AC

Adapter will be installed (reference Figure 5).

13. Remove the adhesive backing from the Velcro

strip on the right-hand side of the tray.

Position the AC Adapter (label side up) over

the Velcro strip with the DC power cord on the

left. Make sure the AC power cord on the right

has enough clearance that it is not tightly

crimped when routed around the adapter.

14. Secure the adapter by firmly pressing it onto

the Velcro.

15. Route the DC power cord through the

cutaway.

Keyboard Plug

58-0710-00A