Fujitsu Stylistic 3400 조립 및 사용 지침 - 페이지 3
{카테고리_이름} Fujitsu Stylistic 3400에 대한 조립 및 사용 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Stylistic 3400 4 페이지. Wall-mount cradle
Fujitsu Stylistic 3400에 대해서도 마찬가지입니다: 사용자 설명서 (3 페이지), 설치 매뉴얼 (4 페이지), 사용자 설명서 (2 페이지), 운영 지침 (1 페이지), 설치 및 사용자 설명서 (8 페이지), 설치 매뉴얼 (1 페이지)
AC Power
Plug
Cutaway
Figure 5. AC Adapter Location
16. Route the AC power cord around the adapter,
as shown in Figure 5. Plug the AC power plug
into the circuit card, and bundle the excess
cable above the adapter.
Final Assembly
17. Carefully position the back assembly inside
the tray assembly so that the six holes in each
are aligned (reference Figures 3 and 6). Use
care when joining the two assemblies; ensure
that no wires or cables are crimped between
the two parts.
Hanger holes
Assembly Screws
Figure 6. Rear of Wall Mount Assembly
4/00
AC Power Cord
DC Power
AC Adapter
Cord
Stylistic 3400 is a trademark of Fujitsu PC Corp. © 2000 Fujitsu PC Corp.
Latch
Cradle
Lock
5
Figure 7. Assembled Wall Mount
18. Using a 3/32 Allen wrench, install the six
short screws from the hardware kit. The
assembled wall mount is illustrated in Fig. 7.
19. After the wall mount cradle is assembled, it
should be mounted to a secure location and
wired to a convenient outlet in accordance
with the user's needs. Typically, the four
hanger holes on the back of the cradle are used
to mount the cradle.
Using the Wall Mount Cradle
The contact pins in the wall mount cradle provide
DC Input and USB interfaces to the pen tablet. The
USB pins are used by the USB keyboard.
Avoid bringing your system in direct contact with the
magnetic latches. Magnetic fields can have an
adverse affect on electronic media, and data on your
hard drive could be damaged or destroyed.
Page 3 of 4
Front
Brackets
Tray
Caution
58-0710-00A