Fujitsu F2MC-8FX Series 운영 매뉴얼 - 페이지 9

{카테고리_이름} Fujitsu F2MC-8FX Series에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu F2MC-8FX Series 21 페이지. 8-bit microcontroller
Fujitsu F2MC-8FX Series에 대해서도 마찬가지입니다: 운영 매뉴얼 (20 페이지), 애플리케이션 노트 (12 페이지), 애플리케이션 노트 (23 페이지), 설정 매뉴얼 (18 페이지), 설정 매뉴얼 (19 페이지), 설정 매뉴얼 (30 페이지), 애플리케이션 노트 (20 페이지), 애플리케이션 노트 (21 페이지), 설정 매뉴얼 (23 페이지), 사용자 설명서 (24 페이지), 설정 매뉴얼 (17 페이지)

4. How to Setup

■ How to the switch and jumper plug on a MCU board setup

Please set the following switches referring to "Figure 6 The switch and jumper plug on a MCU

board".

1. Set the clock selector switch (SW1-1) to ON or OFF to disable or enable the subclock, respec-

tively.

2. Set the clock supervisor selector switch (SW1-2) to OFF.

3. Set the APB8 bus output selector switch (SW1-3) to OFF.

4. Set the C-pin selector switch (SW1-4) to OFF.

5. Set the clock input selector switch (SW2).

Check that value with "5. Setting of the Switch and Jumper Plug ■ Setting of clock input selector

switch (SW2)".

6. Set the product selector switch (SW3) to the value corresponding to the number of pins on the

production MCU.

Check that value with "5. Setting of the Switch and Jumper Plug ■ Setting of the product selector

switch (SW3)".

7. Set the LVD selector switch (SW4) to OFF.

8. Set the power supply selector switch (SW5) to 3 V.

9. Set the jumper plugs.

9-1. Set the subclock selector jumper plug (S1) .

9-2. Set the LVD2 detection voltage jumper plug (S2) to LVD0.

Check that value with "5. Setting of the Switch and Jumper Plug ■ Settings of the subclock

selector jumper plug (S1)".

Check that value with "5. Setting of the Switch and Jumper Plug ■ Setting of the LVD2 De-

tection Voltage Jumper Plug (S2).

GND VCC

PRODUCT SELECT

SC5

SC6

SC4

ADAPTER

Figure 6 The switch and jumper plug on a MCU board

SW5

SW3

1 2 3 4

SW1

SW2

BGM

SW4

SC3

SC2

SC1