Fujitsu FLASH-CAN2-100P-M06 사용자 설명서 - 페이지 10

{카테고리_이름} Fujitsu FLASH-CAN2-100P-M06에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu FLASH-CAN2-100P-M06 20 페이지. F²mc-16lx family

페이지 인쇄

5 Configuration of the Evaluation-Board

The board is configured to work with the MB90F598 microcontroller.

In order to set up the board follow these steps:

1. disconnect power supply disconnected !

2. Set jumper JP1 to provide Vcc, i.e. 5V to the board

3. If case one is connecting this board to an emulator, it is recommended to set jumper JP2

in order to provide 3.7V to the internal core.

4. Please set the mode pins 1-3 on S3 according to your MCU operating mode. ON stands

for 0 and OFF for 1. E.g. MB90F598 all switches to OFF except no. 3.

5. Adjust both potentiometers (P1, P2) clockwise to their end position.

(Check that Pin 8 of U4 and Pin 8 of U5 are grounded.)

6. Select the appropriate CAN interface for the microcontroller you are using by setting

jumper JP3-JP6. Note that Pixx on the silk plot stands for Pinxx, i.e. the pin number.

E.g. for the MB90F598, set JP3 and JP4 to connect Pin 2 and 3 in order to connect to

MCU Pins 74 and 75, respectively.

Target

Series

MB90425

MB90440

MB90470

MB90540

MB90545

MB90550

MB90583

MB90590

MB90595

Table 1: Microcontroller pin-number of the CAN-interface

UG-900001-32

Change even page title here

Chapter 5 Configuration of the Evaluation-Board

CAN0

RX0

TX0

RX1

Pin 75

Pin 74

n.a.

Pin 74

Pin 73

Pin 76

n.a.

Pin 74

Pin 73

Pin 76

Pin 74

Pin 73

n.a.

Pin 75

Pin 74

Pin 97

Pin 75

Pin 74

n.a.

- 10 -

CAN1

CAN2

TX1

RX2

n.a.

Pin 72

Pin 75

(Not supported by

Jumper 3-6 !)

n.a.

Pin 75

n.a.

Pin 98

n.a.

TX2

n.a.

Pin 71

n.a.